Troubleshooting (Initial Setup By Selecting "Bluetooth") - Panasonic HomeHawk WINDOW Information And Troubleshooting Manual

T
roubleshooting (Initial setup by selecting "Bluetooth")
Problem LED color
When initial setup The camera's
LED indicator is
is performed using
blinking in red.
Bluetooth‚ the
following screen is
displayed and the
setup cannot be
completed.
The camera's LED
indicator is lit in
blue.
16
Cause Solution
If the LED indicator is blinking in red‚ unplug the camera and then plug
it in again‚ check the following causes and solutions‚ and then try again
from the beginning.
The wireless network • Enter the correct password for the wireless
password may be
network.
incorrect.
• Unplug the camera and then plug it in again‚
and then try again from the beginning.
The DHCP function of • Confi rm that the wireless router's DHCP settings
your wireless router
are enabled. Refer to your wireless router's
may be disabled.
manual.
• Unplug the camera and then plug it in again‚
and then try again from the beginning.
The address fi lter • Register the MAC address (page 4) of the
function of your
camera to the address fi lter setting of the
wireless router may
wireless router. Refer to your wireless router's
be enabled.
manual.
A network clash has • Unplug all the wireless routers and plug them
occurred because
in again.
you have 2 wireless
If the situation still does not improve‚ refer to
routers at home that
your wireless router's manual for information
are using the same
on how to change the router channel of your
channel or channels
wireless network.
of a close frequency.