Panasonic KX-HNB700 User Manual page 27

Blue
White
Green
Red
*1 You can configure the camera so that its LED indicator does not light during normal operation or
when motion is detected. See "HD camera device profiles", Page 130.
Floor camera LED indicator
Off
Green
Blinking every 1.5
seconds
Red
Yellow
Blue
White
Normal operation, connected to wireless router
Normal operation, connected to wireless router
Camera is searching for wireless router
Initial setup required
Initial setup is in progress with mobile device connected
Initial setup is starting
*1
Motion detected , or camera is starting up
Live images are being viewed or recorded, or camera is starting up
Device malfunction
R No power
R LED indicator is turned off
Registration successfully completed
Registration mode, updating
Camera is searching for your wireless router
Batteries for power backup are in use
*3
Registration failed , signal level is weak
*1
R Streaming data or detecting motion
R Accessing microSD card (when privacy mode is off)
R Camera is out of range of your wireless router
R LED lights are abnormally hot
R Wireless LAN connection failed
Not registered to your wireless router (usually for initial setup), or signal
*2
level is good
Initial setup is being performed using WPS on your router
Registration to your wireless router successfully completed or camera is
*1
on
*1
Privacy mode is on
Accessing microSD card (when privacy mode is on)
Getting started with the HomeHawk!
*1
*3
or signal level is strong
*2
*1
*1
, privacy shutter is open
*1
, privacy shutter is closed
*2
*2
27