Panasonic KX-HNB700 User Manual page 26

Getting started with the HomeHawk!
*1 You can configure the access point so that its LED indicator does not light in most states. See
"Status LED", Page 99.
*2 It may take some time for the access point to finish starting up.
Front door camera and outdoor camera LED indicator
Off
Green
Green or amber
blinking quickly -
off for 1 second
Red
Amber
*1 You can configure the camera so that its LED indicator does not light in most states. See "Status
LED", Page 99.
*2 The LED indicator lights in amber for 5 seconds after the power is turned on for the camera.
*3 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from "Camera signal strength", Page 95.
*4 Motion detection can also be checked from "Detection test", Page 98.
Front door camera and outdoor camera charging LED indicator
Red
HD camera LED indicator
Off
26
IP address is not obtained, or Ethernet cable is not connected to the
router
R No power
R More than 5 seconds have passed since turning on the power when
the camera is not registered to the access point
R LED indicator is turned off
Registration successfully completed or signal level is strong
Registration mode, updating
Camera is searching for an access point
*1
Camera is on
or
Registration failed, signal level is weak
Camera is out of range of the access point
*1
Streaming data
Not registered to the access point
Battery is running low
Charging is completed
Charging
Charging failure
No power, or LED indicator is turned off
*1
*1
*3
, or detecting motion
*1, *3
*2
, or signal level is good
*1
*1
*3
*1, *4
*3