Extreme Networks ExtremeCloud Appliance Series User Manual page 79

Radio as a Sensor on page 72
Advanced AP Radio Settings
Adding or Editing a Configuration Profile
ADSP Support on AP5xx
ADSP Support on AP5xx
The following ADSP features are supported on the AP5xx:
•
LiveView under Sensor Mode
•
LiveView under Radio Share Mode
•
Scan Pattern Support from the ADSP Server for Sensor.
•
Termination under Sensor and Radio Share Modes.
•
Rogue AP on the Wired interface.
•
Threat detection and alarms are supported.
Note
AP Test is not supported.
Related Links
AirDefense Profile Settings
ExtremeLocation Profile Settings
Configure the AP to integrate with ExtremeLocation. ExtremeLocation is a premier location tracking
and analytics solution by Extreme Networks. Using HTTPS with self-signed certificates, an AP opens
WebSocket connections to the ExtremeLocation Server and reports RSS signal strength readings based
on the ExtremeLocation configuration. An ExtremeLocation user associates the Tenant ID and Site
information with the AP MAC address over AP WebSocket.
The AP can be the RSS source for both ExtremeCloud Appliance Positioning and ExtremeLocation at
the same time. RSS information travels both through the WASSP tunnel to the ExtremeCloud Appliance
and through WebSocket to ExtremeLocation.
1 Configure the following parameters:
Table 27: ExtremeLocation Profile Settings
Field
Name
Tenant ID
ExtremeCloud Appliance User Guide for version 4.36.03
on page 75
on page 68
on page 79
on page 78
Description
Name of the ExtremeLocation Profile.
The Tenant ID links the ExtremeCloud Appliance to the tenant,
ensuring that your assets cannot inadvertently be deployed on sites
that belong to other ExtremeLocation accounts. Any modification
made to sites managed by this ExtremeCloud Appliance, such as
adding new access points or sites, is tagged by the ExtremeLocation
Tenant Account Number automatically. The location Tenant ID is
saved to, and retrieved from, the data plane by websocket client,
then sent as session data to the ExtremeLocation server once a
session is established. The Tenant ID can be up to 32 characters.
Configure
79