Extreme Networks ExtremeCloud Appliance Series User Manual page 141

ExtremeWireless APs connected to a Fabric-enabled switch automatically use the default management
VLAN that is configured on the switch. Moving an AP from a Fabric-enabled switch to a non Fabric-
enabled switch requires a factory default reset to connect to the new management VLAN.
Note
When using ExtremeWireless WiNG APs, you must manually set the Management VLAN ID
from the device group Profile.
1 Edit the device group Profile:
2 Select the profile Networks tab.
3 Click
4 From the Network settings page, specify the Default VLAN ID.
Note
In a mobility scenario that includes a local and foreign ExtremeCloud Appliance, make sure
the Fabric Attach topology configuration is the same on each ExtremeCloud Appliance,
ensuring that an AP that moves between appliances has the same set of topologies.
Figure 22: Fabric Attach for FA Clients — Automated Network Services
VLAN Groups
A VLAN group can be associated with a single wireless network. In a large venue, a VLAN group can
support many wireless clients on a single WLAN. The wireless client can associate with any VLAN in the
group. The association is determined by a MAC address hashing algorithm.
Note
Only bridged at AC topologies using AP39xx access points are supported.
To access VLAN Groups, go to Configure > Policy > VLAN Groups.
ExtremeCloud Appliance User Guide for version 4.36.03
to add a network.
Configure
141