Extreme Networks ExtremeCloud Appliance Series User Manual page 108

When you create device groups, then add APs, a list of discovered APs that match the site and device
group configuration settings will display on the Edit Device Group page. You can then select each AP
from the Edit Device Group page to add it to the device group.
Tip
If your APs are not displaying within the Edit Device Group page, verify the following:
•
AP licensing domain matches the site Country value.
•
AP model number matches the site Type and the device group Profile configuration.
Note
You can add several APs and then register them at one time.
1 Go to Configure > Devices > Access Points.
2 To add a new AP, click Add.
3 To add a clone, select the check box next to an AP in the list and click Clone.
4 Configure the following parameters:
Serial Number Unique number that identifies the AP. Provide this number for new and cloned APs. This
number is on the AP.
Model Select an AP model number from the drop-down list. The model number is on the AP.
Name Unique name for the AP. Provide a unique name for new and cloned APs.
Description Text description to help identify the AP.
5 Click OK.
Note
Most AP radio properties depend on a regulatory domain; which is defined at the site level.
Devices that are connected to ExtremeCloud Appliance but not assigned to a device group
have the status of In-Service Trouble. Devices that have not discovered ExtremeCloud
Appliance have the status of Unknown.
Related Links
AP Adoption Rules
Configure AP Radio Settings
To modify settings for an access point (AP) and its radio properties:
1 Go to Configure > Devices > Access Points.
2 Select an AP from the list.
3 (Optional) Enter a description.
ExtremeCloud Appliance User Guide for version 4.36.03
on page 142
Configure
108