Setting The Delivery Table Paper Guides - Neopost HD-CXENVL-FDR V2 Assembly And Operation Manual

Setting the delivery table paper guides

The patented "floating" or tilting delivery table on the HD-CXENVL-FDR is designed to advance the envelopes that
the feed belts deliver, one at a time, into the printer's manual feed tray feed roller.
The delivery table is equipped with self-centering paper guides, an envelope drive belt, and a stop photo sensor at
the end, which is used to stop each envelope in position underneath the printer's feed roller, for take-away by the
printer. An additional envelope sensor is positioned a few inches back from the stop sensor. This is the start
sensor. When the first envelope is pulled away by the printer, the trail edge of that envelope uncovers the start
sensor, which starts the feeder motor. Using the dual sensors allows the HD-CXENVL-FDR to run larger envelopes
and keep pace with the printer.
Step 1.
After the feeder portion has been setup properly and a small stack of envelopes is loaded into the hopper, turn
the speed control knob completely counter-clockwise to set the feeder speed on zero.
Step 2.
Grasp the delivery table paper guides near the bridge and move them outward toward the sides of the machine.
CAUTION: Do not push paper guides at the ends as it may bend the guides.
Speed control knob
Move guides outward. As you move
one guide, the other will also move.
23