Fourier MultiLogPRO User Manual page 11

Before you first use MultiLogPRO, charge the unit for 10 to 12 hours while it is turned
off.
Turn on MultiLogPRO
Press the on button
performs a brief self-check and displays its status including battery level. At this point
you can load the last setup you used (see page 20). If you need a new setup wait
until you see the Main Menu screen:
Plug in the Sensors
Start with the first input on the right. If MultiLogPRO is in Auto ID mode (the default
mode) it will display the setup menu and will identify the sensors you've plugged in.
Note: Sensors must be added successively, starting with input-1. If a single sensor is
used it must be connected to I/O-1. If two sensors are used in an experiment, they
must be connected to I/O-1 and I/O-2.
The arrow indicates that MultiLogPRO is ready to accept a new sampling rate.
Fourier Systems Ltd.
16 Hamelacha St., POB 11681, Rosh Ha'ayin 48091,
Tel: +972-3-901-4849, Fax: +972-3-901-4999
www.FourierEdu.com
. You will see the initialization screen. MultiLogPRO
In–1: Microphone
In–2: Light
In–3:
In–4:
 RATE = 10/s
SAMPLES = 500
DISPLAY = numeric
EXPERIENCE SCIENCE!