GB
plug connections in an area that is safe
from flooding.
•
Ensure that the mains voltage matches
the specifications on the rating plate.
•
The electrical installation shall be ac-
cording to national wiring rules.
•
Connect the equipment only to a sock-
et with a residual current protection
device (residual current circuit breaker)
with a rated current of not more than
30 mA; minimum fuse 6 amperes.
•
Before each use, check the equipment,
cable and plug for damage. Defec-
tive cables are not to be repaired, but
rather replaced by new ones. Have
damage on your equipment repaired
by an authorised specialist.
•
If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
•
Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
•
Do not carry or fix the equipment by
the cable.
•
Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
•
Disconnect the mains plug from the
socket before all work on the equip-
ment, in case of leaks in the water sys-
tem, during work breaks, and when not
in use.
•
The cross-section of mains connection
lines must be no smaller than rub-
ber hose lines with the designation
H07RN-F. The line must be 10 m long.
The flexible lead cross-section of the ex-
tension cord must at least 2.5 mm
8
Start-up
Assembly
1. Screw the angle adapter (11)
2. Position the float switch cable (7)
Connection of the pressure
line
The installation of the submersible water
pump is implemented either
-
with fixed pipe or
-
with flexible hose line
• If using a ½" hose, attach the
• To use a ¾", 1" or 1½" hose, cut
• To use a tap adaptor (G1") to
Measurement of maximum output
data takes place during direct,
straight pumping. The angle adapt-
er (
per (
.
To increase pump output, the backflow
2
stopper (10) may be taken out of the angle
To screw-on the adapter:
and the adapter with the hose
connection (9) onto the pump
outlet (5).
Installing the float switch
in the float switch grid (8).
hose over the pump's hose con-
nection (9) and fasten it with a
hose clamp if necessary.
off the connection above and at-
tach the hose over the correct con-
nection
(fixing with a hose
connect external hose connec-
tion systems, cut off the two top
connections directly above the
G1" tube thread.
11) and the backflow stop-
10) may reduce output.
clamp).