Value Set: Keyed; Value Set: Push; Target Weight Mode - Rice Lake CW-90 Technical Manual

CW-90/90X Checkweigher
5.1.1

Value Set: Keyed

To manually set the OVER/UNDER values with no weight on the scale:
1. Press . The OVER light begins flashing and the value with flashing digit is shown.
OVER
2. Enter the desired over value by using the
or
TARGET
ID
under value.
To discard any changes and return to weigh mode, press the Menu button.
Note
3. When the desired value is displayed, press
4. To change the position of the decimal point, use
5. Press again to accept the value and return to weigh mode.
ENTER
. The UNDER light begins flashing and the value with a flashing digit displays.
6. Press
UNDER
7. Using and
OVER
enter the desired under value. If using the CW-90, the numeric keypad can be used to enter the desired under value.
To discard any changes and return to weigh mode, press the Menu button.
Note
8. When the desired value is displayed, press Enter. The decimal point flashes.
9. To change the position of the decimal point, use
10. Press to accept the value and return to weigh mode.
ENTER
5.1.2

Value Set: Push

To set the OVER/UNDER values using weight on the scale:
1. Place the weight to be determined as over on the scale.
2. Press . The weight is captured and set as the over value. Stored displays and the OVER light flashes.
OVER
3. Place the weight to be determined as under on the scale.
. The weight is captured and set as the under value. Stored displays and the UNDER light flashes.
4. Press
UNDER
5. The ACCEPT band is set as the gap between the OVER and UNDER settings.
5.2

Target Weight Mode

In Target Weight mode, the over and under values can only be set by keying in the values. The VALSET parameter only
pertains to setting the target weight value. The ACCEPT band is determined based on a desired target weight.
40 Visit our website
OVER
to move between digits. If using the CW-90, the numeric keypad can be used to enter the desired
ENTER
to increment/decrement the values and
UNDER
8.00
8.01-12.99
UNDER ACCEPT
Figure 5-3. Example of Under/Over/Target Settings in Target Weight Mode.
www.RiceLake.com
and keys to increment/decrement the values and
UNDER
. The decimal point flashes.
and until it is in the desired position.
TARGET
ID
or
ID
or until it is in the desired position.
TARGET
ID
13.00
OVER
to move between digits,
TARGET
Under = 2.00
Over = 3.00
Target = 10.00