Setting Up the Projection TV Automatically
The initial setup screens appear
only after turning on the projection
TV the first time, or after selecting
Factory Reset in the Setup menu
If you need to set the clock at a
later time, press the TIMER button
on the remote control (see
You can also run Auto Program at
any time from the Channel Setup
menu (see page 58).
You can run the
demonstration again by
selecting Demo from the Setup
menu (see pages 64 to 66).
The first time you turn on the projection TV, a series of screens guide
you through the initial setup of the projection TV. During this setup,
you are prompted to set the clock and start Auto Program, which
searches for and stores a list of analog and digital channels you are
receiving for VHF/UHF and CABLE inputs.
Be sure to complete all connections before turning on the projection TV the
to turn on the projection TV and display the Welcome
to continue Setup. The set clock screen appears.
Move the joystick V and v to set the current day and time (hour,
minute, and AM/PM). Press
each setting and move to the next setting. Move the joystick
go back to the previous setting.
After you've set the clock, move the joystick
to continue Setup. The Auto Program screen
To start Auto Program, press
projection TV automatically creates a channel list of analog and
digital channels. (This may take a few minutes.)
When the channel list is complete, a Congratulations screen
To see a short demonstration of the features of the projection TV,
of the projection TV begins. To exit the demo at any time, press
any button on the remote control (or front panel).
To skip the demo and exit Setup, move the joystick
or move the joystick
A self-running introduction to the features
Setting Up the Projection TV