Sony KDP 57XBR2 Operating Instructions Manual page 85

Problem
Dotted lines
or stripes
Projection TV is fixed to
one channel
Double images or ghosts
Cannot select menu item
Cannot receive any
channels when using
cable TV
Cannot gain enough
volume when using a
cable box
Cannot receive channels
Unable to select a channel
Lost password
Cannot change channels
with the remote control
Cannot cycle through the
other video equipment
connected to the
projection TV
Possible Remedies
Adjust the antenna.
Move the projection TV away from noise sources such as cars, neon
signs, or hair-dryers.
Use Auto Program in the Channel Setup menu to add receivable
channels that are not presently in memory (see page 58).
Check your Channel Fix settings (see page 58).
Use a highly directional outdoor antenna or a cable (if the problem
is caused by reflections from nearby mountains or tall buildings).
If the item you want to choose appears in gray, it is not available to
be selected.
Use Auto Program in the Channel Setup menu to add receivable
channels that are not presently in memory (see page 58).
Check your cable settings.
Increase the volume of the cable box using the cable box's remote
control. Then press TV (FUNCTION) and adjust the projection TV's
volume.
Check antenna connections.
Adjust antenna. If you cannot receive DTV channels, see "Digital
Signal Strength" on page 59.
Use Auto Program in the Channel Setup menu to add receivable TV
channels that are not presently in memory (see page 58).
Use Auto Program in the Channel Setup menu to add receivable TV
channels that are not presently in memory (see page 58).
In the password screen (see page 60), enter the following master
password: 4357. The master password clears your previous
password; it cannot be used to temporarily unblock channels.
Be sure you have not inadvertently switched your projection TV
from channel 3 or 4 setting if you are using another device to
change channels.
If you are using another device to control channels, be sure the
"function" button for that device has been pressed. For example, if
you are using your satellite receiver to control channels, be sure to
press the SAT/CABLE button.
Be sure the Video Input feature has not been set to Skip (see page 65).
Other Information
75