Table of Contents
Advertisement
STEP 1 – FINE TUNING AMPLIFIER SETTINGS
Refer to Chapter 12 for baseline settings before proceeding
with this section.
After you have confirmed and tested that all components
are working you will tune the amplifiers. When setting up
your amplifiers you will refer to the manual inside each
amplifier. However, through hundreds of installations we
have determined the following settings are ideal for the
following STAGE Tuned Audio Packages.
UPGRADES – If you installed the STAGE 5, you are set. However, if you add the subwoofer
system or add rear pods, always check back to this guide to see if your amplifiers should be
readjusted for the new components you have added.
Listen for a clear, crisp audio sound.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
NOTE – Gain control, it is important to
adjust each amplifier gain as described in
the manual. Remember, these settings are
NOT volume controls. Gain controls,
properly adjusted help properly balance the
system sound between lows, highs and
minimize distortion that comes from the
source unit.
©2018 Maxxsonics USA
58
Advertisement
Table of Contents
