Table of Contents
Advertisement
NOTE – On a four seat RZR (4P RZR) you will need to include the 4P jumper to
extend the rear speaker harness, past the rear seats and then to the pods.
Refer to the wiring diagram on Chapter 20 for proper placement in the signal chain.
See FIG 12-4 for quick reference.
INSERT 4P HARNESS HERE
INSERT 4P HARNESS HERE
STEP 5 – Wire up illumination
For speakers that include illumination, there is a small red/black jumper wire and splitter that
connects the rear speakers harness illumination wire to the left and right rear pod illumination.
You will make this connection in the same location as you are connecting the rear pods in the
center console.
The connection location is the same for both the 2 and 4 seats RZR. Refer to the wiring
diagram for proper placement. See FIG X-X for quick reference.
NOTE – Any excess wire that is gathered after the system is tested should be wire
tied and secured under the seat. Do not allow any of the wire harness to touch heat
generating or mechanical components of the machine.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
(FIG 12-4)
©2018 Maxxsonics USA
ILLUMINATION
JUMPER/SPLITTER
INSERT 4P HARNESS HERE
40
Advertisement
Table of Contents
