Table of Contents
Advertisement
20
VEHICLE DISMANTLE
STEP 8 - PULLING DASH BOX
To remove the DIN dash box from the dash, there are three points to address. First, locate the
rear support bracket the down bracket at the rear of the pocket and remove the T-40 Torx
screw.
PHILLIPS SCREW
T-40 TORX
REMOVE CLIP
(FIG 6-8)
Remove the clip shown on the right from the back of this pocket
and set aside for re-use when mounting your new dash source
unit. You will reuse the screw that was in the OEM piece shown in
FIG 6-8.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
©2018 Maxxsonics USA
Advertisement
Table of Contents
