Table of Contents
Advertisement
Next, use your Sharpie to mark the mount holes on the painters tape. Repeat the mounting
process for the other pod shown in FIG 14-2.
STEP 2 - Drill (4) 5/16 inch holes into the fender where you marked the tape shown
in FIG 14-3.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
(FIG 14-2)
(FIG 14-3)
©2018 Maxxsonics USA
44
Advertisement
Table of Contents
