Table of Contents
Advertisement
After you have drilled the hole in the mounting surface, make sure to pull all the wires through
the rubber grommet with the small "door" for the front. This seals the USB and 3.5mm input on
the front face. Additionally, there will be a rubber grommet on the rear of the mounting surface,
all secured by the large nut. See FIG 15-1.
RUBBER GROMMET
FRONT
NOTE – The large thumb nut only needs to be finger tight. Two rubber grommets
help the unit seal to the mounting surface.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
(FIG 15-1)
©2018 Maxxsonics USA
55
LARGE NUT
Advertisement
Table of Contents
