Table of Contents
Advertisement
NOTE - The Dual Amplifier Harness is designed and laid out to perfectly connect
power and speaker connections on the driver's side of the amplifiers while the
RCA audio connections are on the passenger side of the RZR.
Make sure your amplifiers are mounted in the position shown in FIG 11-1. This
configuration is critical to make sure you can access your fine tune adjustments
for crossover and bass boost.
STEP 2 - On the front edge you will secure the plate with the 10mm bolt you removed from the
dash pocket which will also hold the bracket then will ultimately support the new dash pocket
with the source unit also shown in FIG 11-3.
DUAL AMP PLATE
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
(FIG 11-3)
©2018 Maxxsonics USA
34
10mm BOLT
DOWN STRAP
Advertisement
Table of Contents
