Table of Contents
Advertisement
Tighten a few threads at a time on each bolt to allow the subwoofer to rise up against the pull
bar frame evenly. This will allow the subwoofer to seat properly against the frame of the vehicle.
As the subwoofer comes up against the bar, before it is finally secure, make sure that the
speaker wire is not behind the enclosure..
NOTE - When the subwoofer starts to seat into place, push the subwoofer firmly
forward as you tighten the last thread with the mounting nuts.
This forward pressure will be critical when you reassemble the front dash for
fitment into all the clips.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
PUSH ENCLOSURE FORWARD
AS YOU TIGHTEN
©2018 Maxxsonics USA
32
Advertisement
Table of Contents
