Table of Contents
Advertisement
46
STEP 5 - Using the 5/16 inch bolts, washers, and nuts, mount the enclosure shown
in FIG 14-5.
NUTS & WASHERS
(FIG 14-5)
Make sure you use a washer on the inside of the enclosure against the internal wall of the pod
which you sandwich against the fender of the RZR. Use your ½ inch ratchet and wrench to
secure the pod.
Use a small racket and an open box wrench for convenience.
Wire the speaker and illumination if present and use the supplied screws to mount the speaker
to the enclosure.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
©2018 Maxxsonics USA
Advertisement
Table of Contents
