STEP 3 - Remove any tape from the fenders. With the included hardware, mount the pod. The
bolt and 1 washer mount through the fender into the pod. This leaves only the head of the bolt
visible behind the tire shown in FIG 14-4.
NOTE - Make sure that the wires behind the enclosure have remained accessible
for connecting to the harness. Use some painters tape to keep them from getting
blocked by the enclosure.
STEP 4 – Push the included bolt through a washer then through the fender
This will come through the fender and into the kick panel speaker enclosure.
For additional technical information on this and all HIFONICS products, go to the "SUPPORT" tab at HIFONICS.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
(FIG 14-4)
©2018 Maxxsonics USA
45
BOLTS
&
WASHERS