Dmx-512 Control Connection; Dmx-512 Connection With Dmx Terminator - Terbly T90H-WW IP User Manual

6. DMX-512 CONTROL CONNECTION

Connect the provided male side of the XLR cable to the female XLR output of your controller
and the female side of the XLR cable to the male XLR input of the device.You can connect
multiple devices together in a serial fashion.The cable needed should be two core screened cable
with XLR input and output connectors.Please refer to the diagram below.
Address 1 Address 9 Address 17

7. DMX-512 CONNECTION WITH DMX TERMINATOR

For installations where the DMX cable has to run over a long distance or is in an electrically
noisy environment such as in a discotheque it is recommended to use a DMX terminator.This
helps in preventing corruption of the digital control signal caused by electrical noise.The DMX
terminator is an XLR plug with a 120 resistor connected between pins 2 and 3 which is then
plugged into the output (female) XLR socket of the last fixture in the chain.Please see
illustrations below.
T90H-WW IP User Manual XM1307-V1.0-A
11