Device Dmx Start Address Selection; Display - Terbly T90H-WW IP User Manual

8. DEVICE DMX START ADDRESS SELECTION

All fixtures should be given a DMX starting address when using a DMX signal so that the
correct fixture responds to the correct control signals.This digital starting address is the channel
number from which the fixture starts to " listen" to the digital control information sent out from the
DMX controller.The allocation of this starting address is achieved by setting the correct address
number on the display located on the base of the device.
You can set the same starting address for all fixtures or a group of fixtures or set different
addresses for each fixture individually.
If you set the same address on all devices all the devices will start to"listen" to the same control
signal from the same channel number.In other words changing the settings of one channel will
affect all the fixtures simultaneously.
If you set a different address each unit will start to "listen" to the channel number you have set
based on the quantity of control channels of the unit.That means changing the settings of one
channel will affect only the selected device.
In the case of the fixture in 8 channel mode you should set the starting address of the first unit to
1 the second unit to 9 (8 + 1) the third unit to 17 (8+ 9) and so on.

9. DISPLAY

The Display offers several features you can set the starting address run the pre-programmed
program or reset the device.
The main menu is accessed by pressing the -button until the display starts flashing.Browse
-button .Press the Enter-button in order to
through the menu by pressing the -button
select the desired menu.You can change the selection by pressing the -button
-button.Confirm every selection by pressing the -button.You can leave every mode by
pressing the -button.After accessing the edit mode the unit will automatically exit to the
main menu after 15 seconds from the last button press.When the unit is powered on if no data
signal is connected after 1 minute then the display will switch off automatically.The Display
does not need external power to operate.Hold down the -button for 10 seconds and the
Display will turn on by using the unit's battery built in battery.
Default settings shaded
T90H-WW IP User Manual XM1307-V1.0-A
12