Installation Of Other Devices; Electrical Connections - King gates OVO550 Instructions And Warnings For Installation And Use

21
09. Then secure the leaf connecting bracket [N] with rivets or screws
(fig. 21). Use screws or rivets suited to the leaf material, and ensure
that they are able to withstand the maximum force required for leaf
opening and closing.
10. Loosen the screws of the two mechanical stops, then move the
front mechanical stop [P] in front of the carriage (fig. 22).
22
Q
11. Push the carriage in the closing direction and, on reaching the
position, tighten the screw [Q] fully down.
12. Manually open the door to the required opening position, move
the rear mechanical stop [R] next to the carriage (fig. 23) and tighten
the screw [Q] fully down. Important! - Make sure the release cord
can be pulled below a height of 1.8 m.
23
R
Q
3.3 -

Installation of other devices

If other devices are needed, install them following the directions pro-
vided in the corresponding instructions. Check the devices which
can be connected to OVO in fig. 1 and in section 3.5 ("Description of

electrical connections").

3.4 -
01. Open the cover by loosening the screw (fig. 24) and pushing the
O
button (fig. 25).
24
N
25
P
02. Remove the small disc [S] with a screwdriver (fig. 26).
26
03. Feed the cables through the hole [S] (fig. 27).
27
04. Refer to fig. 28 and the connection descriptions in table 5 when
making the connections:
- if using photocells, remove the wire clip between terminals 3 and 7
and follow the connection diagram in fig. 28.
- if using the flashing light aerial, remove the wire clip (connected to
terminal 2 as standard) and connect the RG58 shielded cable.
Electrical connections
S
S
7