Vinten FH155 Manual User Manual page 14

Installation
1. Adjusting the backplate
(A) Stepped adjustment– Using a 5 mm Allen key, remove
the three centre screws and pull the camera cradle off the tilt
mounting.
12
(A)
Reposition the cradle
as desired, then
reattach using the
centre screws.
If necessary, remove
the mounting plate.
2. Adjusting the mounting plate
(B) Stepped adjustment – Adjust the mounting plate by
removing the two side screws and washers and moving the plate
to the required attachment point on the side of the backplate.
Reattach using the screws and washers.
(B)
(C)
Slide adjustment – Loosen the two
mounting plate side screws enough to adjust
the plate by sliding it up or down. Ensure the
side screws are securely tightened before
mounting the payload.