Cable Management; Powering Up; Configuring The Head - Vinten FH155 Manual User Manual

Cable Management

To ensure a safe and tidy installation, all cables connected to the
head should be dressed and secured using the cable management
bracket supplied. Cables can also be secured to the tripod leg using
the cable ties provided.
CAUTION! Leave sufficient slack in the cables between
!
the fixed mounting and the head for free and full range of
movement.
CAUTION! Cables must be secured to the cable
!
management bracket when the head is mounted to a tripod.

Powering Up

WARNING! Ensure that all personnel are clear from the
!
robotic equipment before powering up.
WARNING! Unexpected movement may occur.
Risk of trapped hand / fingers.
!
CAUTION! Disengage the tilt lock before powering up.
Before powering up the head, ensure that all external cable
connections have been secured. To power up, press the power
button located on the side of the head. The head will not move when
powered up, but zoom and focus servos on the camera will take up
their default positions on analogue lenses.
The LEDs located at the rear of the head indicate that data
communications (green LED) and a genlock signal (amber LED)
is present. If the LEDs do not illuminate on power up, refer to the
Troubleshooting section of this manual (see page 20).
Note: FH-155 models only – The head can be switched to
MANUAL mode using the control switch on the side of the head; this
disengages the robotic drives and engages the drag modules.

Configuring the Head

The head can now be configured for the studio environment using the
Advanced Configuration Tool software.
Refer to the V4063-4980 VRC System User Guide, Advanced
Configuration Tool section.
Installation
17