Vinten FH155 Manual User Manual page 5

Electrical Connections
WARNING! This product must be connected to a power
supply of the same voltage (V) and current (A) as
indicated on the product and described in the Technical
Specifications section of this manual. To reduce the risk of
electric shock, do not remove the covers.
No user servable parts inside. Refer all servicing to
qualified serv personnel.
WARNING! The IEC connector is the primary disconnect
dev and must be accessible both during and after
installation of the product.
WARNING! Inspect the AC cable regularly for signs of
wear or damage. If the AC cable is damaged, the product
must be returned to Vinten for repair.
CAUTION! Only use the power cable specified for the
!
products and certified for the country of use.
Supplied power cable V4101-5008
CAUTION! Using alternative cables will invalidate the
!
system EMC liability and product warranty.
Supplied power cable V4101-5008
WARNING! When wiring directly to a studio power supply,
the product must be connected to a switched 3A fused outlet.
WARNING! This product is Class 1 equipment. For safe
operation this equipment must be connected to a power
supply that has a protective earth connection (US: ground).
Operating Environment
CAUTION! The product should not be used outside the
!
operating temperature limits. Refer to the product technical
specifications for the operating limits for the product.
WARNING! This product is designed for Indoor use only.
!
Do Not use outdoors.
Safety and Warnings
Mounting and Installation
WARNING! Always ensure that all power and auxiliary
!
communications cables are routed so that they do not
present any danger to personnel. Take care when routing
cables in areas where robotic equipment is in use.
Ventilation and Overheating
CAUTION! Slots and openings are intended for ventilation
!
purposes to ensure reliable operation of the product and
protect it from overheating. Do not block or cover any slots
or openings.
Cleaning and Maintenance
CAUTION! Do not use solvent or oil-based cleaners,
!
abrasives or wire brushes to remove accumulations of
dirt as these damage the protective surfaces. To clean
mechanical surfaces, use only detergent-based cleaners
CAUTION! Do not use oil or grease on any exposed part
!
of the product. This is unnecessary and traps dirt which
acts as an abrasive
WARNING! The tilt lock MUST be engaged whenever
!
the head is lifted or transported and before installing or
adjusting the camera or payload.
CAUTION! Risk of damage to equipment. Do not lift or
!
carry the head by the back cover.
WARNING! Risk of electric shock. Always disconnect
and isolate the product from the power supply before
cleaning.
3