Stopping A Seal Cycle In Progress - Agilent Technologies PlateLoc User Manual

74 Chapter 4: Sealing plates
PlateLoc User Guide

Stopping a seal cycle in progress

About this topic
Standalone device
procedure
Lab automation
system procedure
This topic explains how to stop the PlateLoc when a seal cycle is in
progress. You can use this method to stop the device in an emergency.
To stop a seal cycle that is in progress:
1. On the Main Menu , press STOP.
Main Menu
Seal Time:
S e t T i m e : 1 . 8 S e c o n d s
Seal Temp:
S e t Te m p : 1 6 0 D e g r e e s C
Status: Running
A i r p r e s s u r e : 8 9 p s i
Setup
To stop a seal cycle in an emergency:
1. In case the STOP button on the touch screen does not work or is not
responding fast enough, turn off the PlateLoc. The on/off switch is
on the back of the device. Alternatively, you can disconnect the
power to the PlateLoc.
The following diagram shows the location of the on/off switch and
the power connection on the back of the PlateLoc.
00191 00191
PlateLoc PlateLoc
connections connections
You can stop a seal cycle from the Velocity11 lab automation system
software. For detailed instructions, see the Velocity11 lab automation
system software user guide.
1.8s
S
T
160°C
O
P
00206
PlateLoc
screen menu 1
Press to stop the seal
cycle in progress.
Press to turn off.
Disconnect power.