Loading And Unloading A Roll Of Seal - Agilent Technologies PlateLoc User Manual

Loading and unloading a roll of seal

About this topic
Before you start
Loading procedure
This topic explains how to load and unload a roll of seal on the
PlateLoc.
Make sure you have the supplied seal-loading card.
To warm up or cool down the PlateLoc:
1. Make sure the PlateLoc is turned on.
2. Make sure the air is turned on (the PlateLoc door automatically
opens when you turn on the air).
3. From the touch screen Main Menu , press Setup.
Main Menu
Seal Time:
S e t T i m e : 1 . 8 S e c o n d s
Seal Temp:
S e t Te m p : 2 0 D e g r e e s C
Status: Ready
A i r p r e s s u r e : 8 9 p s i
Setup
4. In the Set Parameters Menu that appears, set the Seal Temp at
30–40
°C.
Set Parameters Menu
Set Seal Time: 1.8s
Set Seal Temp: 35°C
Service
V e r s i o n 3 . 7 . 2 C y c l e c o u n t :
5. Press Done to save the new temperature setting and return to the
Main Menu.
6. Wait for the PlateLoc to warm up or cool down to 30–40
To assemble a roll of seal on the axle and hubs:
1. Remove the seal roll, seal-roll hubs, and axle from their packaging.
2. Screw one of the hubs onto the axle.
3. Place the axle through the hole at the center of the seal roll. Make
sure the hub fits snugly against the roll.
1.8s
R
20°C
U
N
00206
PlateLoc
screen menu 1
00207 00207
PlateLoc PlateLoc
screen menu 2 screen menu 2
Done
6 3 7 7 9
Chapter 3: Getting started
PlateLoc User Guide
Press Setup.
Press arrows to
set temperature.
.
°C
53