Meeting Lab Requirements - Agilent Technologies PlateLoc User Manual

Meeting Lab requirements

About this topic
Lab space
This topic describes the requirements for installing the PlateLoc.
The weight and dimensions of the PlateLoc are as follows:
Dimension
Weight
Width
Height (with seal mounted)
Depth (with door open and seal mounted)
21.6 cm (8.50 in)
58.4 cm (23.0 in)
When planning lab space for the PlateLoc, you should consider the
following:
Make sure the lab bench can support the weight of the PlateLoc, and
the surface is level.
Provide adequate bench space for the PlateLoc.
Make sure there is sufficient clearance around the PlateLoc so that
you can reach the back of the device to turn off the power and air in
an emergency.
Place the PlateLoc within 1.8 m (6 ft) of the electrical outlets.
Place the PlateLoc within 4.6 m (15 ft) of the air source.
Gas-Purging PlateLocs only. Place the PlateLoc within 4.6 m (15 ft) of
the argon source.
Chapter 2: Unpacking and installation
PlateLoc User Guide
Value
20 kg (45 lb)
21.6 cm (8.50 in)
58.4 cm (23.0 in)
39.9 cm (15.7 in)
39.9 cm (15.7 in)
23