Turning On And Turning Off The Air - Agilent Technologies PlateLoc User Manual

44 Chapter 3: Getting started
PlateLoc User Guide

Turning on and turning off the air

About this topic
Before turning on
the air
Turning on the air
This topic explains how to turn on and turn off the air to the PlateLoc.
Make sure:
You have properly installed the PlateLoc.
The air is turned on at the source (house, cylinder, or pump) and the
air pressure and flow rate meet the PlateLoc requirements.
The PlateLoc is turned on.
To turn on the air:
1. Push the AIR ON/OFF switch to the ON position.
The following diagram shows the location of the air ON/OFF switch
on the back of the PlateLoc. The ON/OFF switch in the diagram is in
the OFF position.
00191 00191
PlateLoc PlateLoc
connections connections
When you turn on the air, the PlateLoc door opens. If this is the first time
you are turning on the air, you must remove the packing foam inside the
sealing chamber before you can use the device.
!! IMPORTANT !! Save the packing foam in case you need to move
or ship the PlateLoc. The packing foam is designed to protect the
device. Packing the PlateLoc using other materials can damage the
device and void your warranty.
Push to turn on.
Remove the packing foam
before use.