Turning On And Turning Off The Power - Agilent Technologies PlateLoc User Manual

42 Chapter 3: Getting started
PlateLoc User Guide

Turning on and turning off the power

About this topic
Before turning on
the PlateLoc
Turning on the
PlateLoc
This topic explains how to turn on and turn off the power to the
PlateLoc.
Make sure:
The lab requirements are met.
You have properly installed the PlateLoc.
You are trained in the proper operation of the PlateLoc.
To turn on the PlateLoc:
1. Press the on/off switch on the back of the PlateLoc to the on
position (I).
The following diagram shows the location of the on/off switch on
the back of the PlateLoc. The on/off switch in the diagram is in the
on position.
00191 00191
PlateLoc PlateLoc
connections connections
When you turn on the PlateLoc, the touch screen displays the
Insufficient Air Pressure error message. This is because you have not yet
turned on the air to the PlateLoc. Proceed to "Turning on and turning off
the air" on page 44 to turn on the air.
Press to turn on.