Unpacking The Plateloc - Agilent Technologies PlateLoc User Manual

Unpacking the PlateLoc

About this topic
Unpacking
precautions
Unpacking the
PlateLoc from its
shipping container
This topic explains how to unpack the PlateLoc.
When unpacking the PlateLoc, be sure to:
Note the dimensions of the shipping container before moving it to
make sure you have adequate clearance through doorways and
passages.
Make sure the final location is nearby and easily accessible.
Use care when lifting the PlateLoc to prevent personal injury and
damage to the device. The PlateLoc weighs 20 kg (45 lb) and might
require two people to lift it.
The PlateLoc and its components are shipped in two shipping
containers:
The PlateLoc container. Contains the main body of the device and all
the items you need to install and operate the PlateLoc.
The seal roll container. Contains a roll of seal.
To unpack the PlateLoc and the roll of seal:
1. Open the top of the PlateLoc container.
2. Remove the thin layer of packing foam.
3. Remove the inner box and set it aside.
4. Carefully lift the PlateLoc out of the shipping container.
5. Remove the packing foams on the left and right sides of the device.
6. Remove the PlateLoc from the plastic bag and set it carefully on the
lab bench or final location where you want to install the device.
Note: A small block of foam pieces is packed inside the PlateLoc.
You will remove the packing foam after you install the device and
turn on the air.
7. Open the inner box and remove the components from the box.
8. Open the seal roll container, remove the roll of seal, and remove the
seal from the plastic bag.
!! IMPORTANT !! Save the packing materials and shipping
container in case you need to move or ship the PlateLoc.
!! DAMAGE HAZARD !!
container were designed to protect the device. Packing the PlateLoc
using other materials and containers can damage the device and
void your warranty.
Chapter 2: Unpacking and installation
The packing materials and shipping
27
PlateLoc User Guide