Frequency And Percentage Reference Channel; Actual Value Display - BONFIGLIOLI Vectron ACTIVE Manual

5.7
The varied functions for the specification of the reference values are connected in the
various configurations by the frequency or percentage reference channel. The
ence frequency source
additive connection of the available reference sources as a function of the installed
hardware.
2 -
4 -
12 -
14 -
22 -
24 -
34 -
35 -
102 to 135
Alongside the operation modes listed, those stated in the operating instructions of the
frequency inverter in the chapter "Frequency reference channel", and in the chapter
"Percentage reference channel" also apply.
5.8
The actual values of speed sensor 2 can be read via the parameters
sensor 2
The analog input signal on analog input EM-S1INA can be a voltage or a current signal
depending on the setting of switch S3. Accordingly, the actual value parameter
input EM-S1INA
The analog output signal on analog output EM-S1OUTA can be read via the actual value
parameter
The analog output signal on analog output EM-S2OUTA can be read via the actual value
parameter
66
66

Frequency and percentage reference channel

475, and the
Operation mode
Abs. Value EM-S1INA
Abs. Value, MFI1A + EM-
S1INA
Abs. Value, EM-S1INA
+ FF (and/or FP)
Abs. Value, MFI1A + EM-
S1INA
+ FF (and/or FP)
Abs. Value EM-S1INA +
MP
Abs. Value, MFI1A + EM-
S1INA + MP
Abs. Value, speed sensor
2 (F2)
Abs. Value MFI1A + F2

Actual value display

Speed, speed sensor 2
219 and
253 is displayed as a percentage.
Analog output EM-S1OUTA
Analog output EM-S2OUTA
Reference percentage source
Function
Reference source is the analog input EM-S1INA.
Reference sources are the multifunctional input
MFI1A and the analog input EM-S1INA.
Reference sources are the analog input EM-S1INA
and fixed frequency FF (and/or the fixed percentage
FP)
Reference sources are the multifunctional input
MFI1A, analog input EM-S1INA and fixed frequency
FF (and/or the fixed percentage FP)
Reference sources are the analog input EM-S1INA
and the motor potentiometer function MP.
Reference sources are the multifunctional input
MFI1A, analog input EM-S1INA and the motor poten-
tiometer function MP.
The frequency signals in
sor 2
493 are evaluated as a reference value.
Reference sources are the multifunctional input
MFI1A and the frequency signals in
Speed Sensor 2
493.
Operation modes with signs (+/-)
220.
266.
268.
Refer-
476 determine the
Operation mode Speed sen-
Operation Mode
Frequency speed
analog
06/05
06/05