Lan1/Lan2 Network Configuration - ICP DAS USA LP-22 Series User Manual

2.5. LAN1/LAN2 Network Configuration

After logging into the LinPAC AM335x PAC successfully, the user can use 'ifconfig' command to get
the IP address of LAN1/LAN2. The LAN 1/2 of factory setting use DHCP. If user would prefer to
setup the IP address for static mode, the following steps for reference:
Step 1: Using the Linux command 'vi' to modify the file '/etc/network/interfaces'.
Step 2: Using the '#' to mark the default configuration.
Remove the '#' comment from each line in the static IP block and comment out the DHCP block by
adding '#' to each entry. Entry the relevant IP, Netmask and Gateway details in the respective
Assign IP block entries. (Refer to the Figure 2.5-1)
Figure 2.5-1. Network configuration
Step 3: After user save the file and use 'reboot' command to reset the device, user can use the
new network configuration on LinPAC AM335x PAC.
AM335X-PAC Series User Manual version 2.0.1 Page: 38
Copyright © 2019 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com