Declarations; Declaration Of Incorporation - Siemens KMS Assembly And Operating Instructions Manual

12.

Declarations

12.1

Declaration of incorporation

in accordance with Directive 2006/42/EC, Annex II 1 B
The manufacturer, Siemens AG, 46395 Bocholt, Germany, declares with regard to the partly completed
machinery
– The special technical documents described in Annex VII B have been prepared.
– The following basic health and safety requirements set out in Directive 2006/42/EC, Annex I, are applied
and are satisfied:
1.1, 1.1.2, 1.1.3, 1.1.5; 1.2.4.4, 1.2.6; 1.3.1, 1.3.2, 1.3.3, 1.3.4, 1.3.6, 1.3.7, 1.3.8, 1.3.8.1;
1.4.1, 1.4.2.1; 1.5.1, 1.5.2, 1.5.4, 1.5.5, 1.5.6, 1.5.7, 1.5.8, 1.5.9, 1.5.10, 1.5.11, 1.5.13;
1.6.1, 1.6.2; 1.7.1, 1.7.1.1, 1.7.2, 1.7.4, 1.7.4.1, 1.7.4.2, 1.7.4.3
– The partly completed machinery must not be put into service until it has been established that the
machinery into which the partly completed machinery is to be incorporated has been declared to be in
conformity with the provisions of Directive 2006/42/EC, as appropriate.
– The partly completed machinery is in conformity with the provisions of the:
Directive 2014/34/EU
Directive 94/9/EC
– The manufacturer undertakes, in response to a reasoned request by the national authorities, to transmit in
electronic form relevant information about the partly completed machinery.
– The person authorised to compile the relevant technical documentation is:
Mark Zundel / Head of PD MD AP VOE
Voerde, 2015‐12‐15
Voerde, 2015‐12‐15
Translation of the original declaration of incorporation
Declaration of incorporation
Vertical mill gear unit
KMS
Sizes 225 to 850
for driving vertical mills:
OJ L 96, 29.03.2014, p.309-356
OJ L 100, 19.04.1994, p.1-29
Mark Zundel / Head of PD MD AP VOE
Björn Podewski / Head of PD MD AP VOE BA
BA 9137 en 12/2015
87 / 89
(effective from 20.04.2016, 00:00 a.m.)
(effective until 19.04.2016, 12:00 p.m.)