General Notes; Introduction; Copyright - Siemens KMS Assembly And Operating Instructions Manual

2.

General notes

2.1

Introduction

These instructions are a part of the gear unit delivery and must always be kept on hand near the gear unit.
NOTICE
Property damage
Damage to the gear unit or occurrence of operating failures is possible.
All persons carrying out work on the gear unit must have read and understood the instructions and must
adhere to them.
Siemens accepts no responsibility for damage or disruption caused by disregard of these instructions.
The "FLENDER Bevel-helical gear unit" of the type "KMS" described in these instructions has been
designed for driving a vertical mill.
The gear unit is designed only for the application specified in the order-specific gear unit documentation.
Deviating operating conditions require new contractual agreements.
The gear unit is manufactured in accordance with the state of the art and is delivered in a condition ready
for safe and reliable use. The gear unit complies with the requirements in Directive 2014/34/EU.
The gear unit may only be used and operated in accordance with the conditions laid down in the service
and supply contract concluded between Siemens and the customer.
The gear unit described in these instructions conforms to the state of technical development at the time
when these instructions went to print.
In the interest of technical further development we reserve the right to make changes to the individual
assembly groups and accessory parts as we deem appropriate in order to increase their capacity and
safety while maintaining their essential characteristics.
2.2

Copyright

The copyright to these instructions is held by Siemens AG.
These instructions may be used neither in full nor in part for competitive purposes nor be made available
to third parties without our approval.
Technical enquiries should be directed to our factory or to one of our customer service centres:
Siemens AG
Am Industriepark 2
46562 Voerde
Tel.: +49 (0)2871 / 92‐0
Fax: +49 (0)2871 / 92‐1544
BA 9137 en 12/2015
10 / 89