Declarations; Declaration Of Incorporation; Declaration Of Conformity - Siemens FLENDER H SH Series Assembly And Operating Instructions Manual

12.

Declarations

12.1

Declaration of incorporation

in accordanc
e with Directive 2006/42/EC, Annex II 1 B
The manufacturer, Siemens AG, 46395 Bocholt, declares with regard to the partly completed machinery
‐ The special technical documents described in Annex VII B have been prepared.
‐ The following basic health and safety requirements set out in Directive 2006/42/EC,
Annex I, are applied and are satisfied:
1.1, 1.1.2, 1.1.3, 1.1.5; 1.2.4.4, 1.2.6; 1.3.1, 1.3.2, 1.3.3, 1.3.4, 1.3.6,1.3.7, 1.3.8, 1.3.8.1; 1.4.1, 1.4.2.1;
1.5.1, 1.5.2, 1.5.4, 1.5.5, 1.5.6, 1.5.7, 1.5.8, 1.5.9, 1.5.10, 1.5.11, 1.5.13; 1.5.15; 1.6.1, 1.6.2; 1.7.1,1.7.1.1,
1.7.1.2; 1.7.2; 1.7.4,1.7.4.1, 1.7.4.2, 1.7.4.3
‐ The partly completed machinery must not be put into service until it has been established
that the machinery into which the partly completed machinery is to be incorporated has been
declared in conformity with the provisions of Directive 2006/42/EC, as appropriate.
‐ The partly completed machinery is in conformity with the provisions of the Directive(s):
94/9/EC
‐ The manufacturer undertakes, in response to a reasoned request by the national authorities,
to transmit in electronic form relevant information about the partly completed machinery.
‐ The person authorised to compile the relevant technical documentation is:
Friedheim Schreier (Director SGU Engineering)
Penig, 2013‐02‐07
Penig, 2013‐02‐07
Declaration of incorporation
Gear unit
H.SH, H.VH, H.HH, H.DH, H.KH, H.FH,
H.HM, H.DM, H.KM, H.FM, H.PH
B.SH, B.VH, B.HH, B.DH, B.KH, B.FH,
B.HM, B.DM, B.KM, B.FM
Sizes 1 to 22
for driving machines in general engineering applications:
Friedheim Schreier (Director SGU Engineering)
Michael Kupke (Director Business Subsegment SGU)
BA 5030 en 02/2013
94 / 96