Set-Up Conditions; Dimensions And Weights; Lifting Device - Siemens KMS Assembly And Operating Instructions Manual

DANGER
Electrostatic discharge
Danger to life from ignition of present explosive atmosphere by electrostatic discharge.
A potential equalisation in accordance with the applying regulations and directives must be carried out.
Threaded holes for an earth connection are provided on the gear units or on the output flange. This work
must always be done by trained electricians.
NOTICE
Property damage
Damage to the gear unit from dropping objects, heaping over, welding work or inadequate fastening.
The operator must ensure the following:
– The gear unit must be protected against dropping objects and heaping over.
– No welding work may be done at all on the drive.
– The gear unit must not be used as an earthing point for electrical welding work.
– All the fastening points provided by the design of the unit must be used.
– Screws which have been damaged during assembly or disassembly work must be replaced with
new screws of the same strength class and type.
Note
When fitting in the vertical mill, the mill manufacturer's special instructions must be observed.
Note
Every time the drive is set in motion and any operation of the oil-supply system (with connected gear
unit) represents a start-up.
6.2

Set-up conditions

As early as during the planning phase, sufficient space must be allowed around the gear unit for later care
and maintenance work.
Note
It must be ensured that the oil can be drained and an adequate air supply is provided. It must be
possible to check the internal parts through the holes in the inspection hole covers.
Upstream and downstream machines have to be arranged accordingly.
If the pipes connecting the gear unit and oil-supply system are included in the Siemens delivery, the
installation plan is enclosed with the documentation.
6.2.1

Dimensions and weights

Refer to the drawings in the gear unit documentation and the order-specific data sheet for details regarding
weight and further technical data.
6.2.2

Lifting device

Adequate lifting gear must be available before beginning the fitting work.
The load-bearing capacity of the lifting gear used or to be installed must correspond at least to the weight
of the product that is to be transported (for details see section 1. "Technical data").
For information about transport please refer to section 4. "Transport and storage."
BA 9137 en 12/2015
39 / 89