If Pyrolytic Cleaning Is Cancelled - Miele H2561BP Operating And Installation Instructions

Cleaning and care
 The amount of soiling, e.g. ash, left in
the oven will vary depending on how
dirty the oven was to start with.
The fibre glass seal around the front
of the oven should be handled
carefully. Do not rub and scour it.
If possible you should avoid trying to
clean it.
Tips
– Most soiling can be easily removed
using a clean, damp microfibre cloth,
or with hot water and a little washing-
up liquid on a clean sponge.
– Depending on how dirty the oven was
there may be a visible layer of soiling
across the inner glass pane on the
door. This should be removed using
the reverse of a non-scouring
washing-up sponge or with a
stainless steel spiral pad and a little
washing-up liquid.
– Spilt fruit juices may cause lasting
discolouration to enamelled surfaces.
This discolouration is permanent but
will not affect the efficiency of the
enamel. Do not attempt to remove
these marks.
82

If pyrolytic cleaning is cancelled

If the Pyrolytic cleaning programme is
cancelled the oven door will remain
locked until the temperature inside the
oven drops to below 280 °C. The 
symbol will light up until the
temperature has dropped below this
level. The door can be opened as soon
as the  symbol starts flashing.
The following will cause the Pyrolytic
cleaning programme to stop:
– turning the function selector to a
different function or to the 0 position.
Turn the function selector back to the
Pyrolytic cleaning programme
position , if you want to restart
the programme.
– A power cut.
When power is restored  will light
up until the oven temperature drops
below 280 °C. After that the number
block will become visible in the
display, the  symbol will start
flashing and the door will unlock.
 will then start flashing in the
display.
 To restart the Pyrolytic cleaning
programme press the OK button. You
can then reselect the cleaning
programme and start it.
If you turn the function selector to the
0 position after a power cut,  will
continue flashing. Confirm with OK to
set the time of day again (see "Before
using for the first time").