Emerson Rosemount 148 Reference Manual page 26

Configuration
June 2019
Note
The Rosemount 148 must be configured before installation.
This can be done in one of two ways:
• Ordering factory configuration by Emerson
• Using the Rosemount 148 PC Programmer interface in a bench configuration setting
3.3.1 Software installation
Procedure
1. Place the Rosemount
2. Run setup.exe from Windows
3. When first using the software, configure the appropriate COM ports by selecting
4. Install MACTek
3.3.2 Rosemount 148 programming
Table 3-1: Programming Kit Spare Part Numbers
Product description
Programming software (CD)
Rosemount 148 programmer kit — USB
Rosemount 148 programmer kit — serial
3.3.3 PC Programmer hardware setup
The Rosemount
communication modem. The Rosemount 148 device will need an external power supply of
12–42.4 Vdc for configuration.
Procedure
1. Hook up the transmitter and a load resistor (250–1100 Ω) wired in series with the
2. Attach the modem in parallel with the load resistor and connect it to the PC.
Postrequisites
See Table 3-1
26
™
148 PC Programmer CD_ROM into the drive.
Port Settings from the Communicate menu.
®
Modem drivers completely before beginning bench configuration
on the Rosemount 148 system.
Note
The software defaults to the first available COM port.
™
148 PC Programming Kit includes configuration software and a
power supply.
for spare kit and re-order numbers.
™
XP, 7, 8, or 10.
Part number
00148-1601-0002
00148-1601-0003
00148-1601-0004
Reference Manual
00809-0100-4148
www.Emerson.com