Section 4
Mounting
4.3.4
26
Semi-flush mounting protection relay inclined
A mounting kit is needed for semi-flush mounting the protection relay inclined. In
addition to the detailed mounting instructions, the mounting kit includes:
•
Angle frame
•
Gasket
•
Screws
Requirements for installation
•
Panel cut-out of 6.57 × 7.99 inches (167 × 203 mm) with mounting holes
•
Depth behind the panel 4.21 inches (107 mm)
•
When IP 54 degree of protection (according to IEC 60529) is required for the front
side, a gasket has to be used in the installation.
1.
Mount the angle frame into the panel cut-out with four M4 screws.
1MAC051065-MB K
615 series ANSI
Installation Manual