1MAC051065-MB K
Section 5
5.1
5.2
615 series ANSI
Installation Manual
Connecting
Required tools
Only use a screwdriver and insert bits for Phillips (PH 2) cross-recessed head screws when
handling CT/VT terminals (X120) of screw-compression type.
A
A071178 V2 EN
Figure 25:
Screwdriver for CT/VT terminals of screw-compression type
A Max. ∅0.22 inches (5.5 mm)
B
A
A071180 V2 EN
Figure 26:
Insert bits for CT/VT terminals of screw-compression type
A Min. 0.59 inches (15 mm)
Connecting wires
All connections are made on the rear of the case. No soldering is needed.
Section 5
Connecting
39