Adding Other Sources To The Floor Mix - Shure Microflex Complete Wireless MXCW Complete User Manual

Adding Other Sources to the Floor Mix

Add other audio sources to blend with the floor mix of MXCW wireless microphones.
• 1 XLR analog input on the access point is automatically routed to the floor
• 10 Dante digital network channels are selectable for routing
1. Connect the audio source to the system:
◦ Analog input: Connect an audio source to the XLR input on the access point.
Tip: Flip the ground lift switch if a buzzing or humming sound occurs because of a ground loop.
◦ Digital audio: Route audio to one of the MXCW Dante channels using Dante Controller software.
2. Ensure the sources are selected on the floor group.
3. If necessary, adjust the volume level or EQ to match the other input levels from Audio > Inputs.
Tip: Always use AGC on each channel for automatic, continuous volume optimization.
Removing a Microphone from the Floor
By default, the audio from any active microphone is routed to the floor mix. However, you can remove a conference unit from
the floor mix if you do not want it to go to the loudspeakers.
For example, a chairman's conference unit can be recorded but kept private (taken out of the floor mix). Remove it from the
floor mix and route it to another group that is connected to a recording system for archival purposes.
1. Go to Audio > Group mixes > Floor.
2. Find the seat you want to remove and deselect it.
Tip: Select Show connected seats only to filter out unoccupied seats.
Shure Incorporated
65/101