Installation; Additional Equipment; Requirement Checklist - Shure Microflex Complete Wireless MXCW Complete User Manual

2. Place the charger in storage mode:
◦ From the hardware: Press and hold the Storage mode button for 5 seconds.
◦ From the software: Open the charger web application to the home page and turn on storage mode.

Installation

Additional Equipment

Network Cables
Audio Cables
Gigabit DHCP Router (sys­
tems with >1 APT)

Requirement Checklist

Make sure your equipment meets these requirements before installing the system:
• Use shielded Cat 5e or higher Ethernet cables.
• Use Gigabit networking equipment between network audio devices.
Use shielded Cat5e (or higher) Ethernet cables, limiting cable runs to 100 meters maximum
between network devices.
Balanced XLR cables to use analog input/output from the access point.
A DHCP router is recommended to connect multiple access points in the same installation.
Ensure that it meets the following requirements:
• Gigabit ports
• Provides Class 0 PoE with at least 6.5W (for powering the MXCW access point)
• Quality of Service (QoS) with 4 queues
• Diffserv (DSCP) QoS, with strict priority
• If the router features Energy Efficient Ethernet (or Green Ethernet), ensure it is disabled
from the ports dedicated for the MXCW system.
• Recommended: A managed switch to provide detailed information about the operation
of each network link: port speed, error counters, bandwidth used, etc.
Shure Incorporated
26/101