Table of Contents
Advertisement
DIS Digital Conference System
Important
Installation precautions
Do not install the unit in a location near heat
sources such as radiators or air ducts, or in a place
exposed to direct sunlight, excessive dust or
humidity, mechanical vibration or shock.
Electrostatic discharge may cause the following
conference units to restart. If such events occur,
the conference units will self-recover.
•
DM 6680 P
•
DM 6680 F
•
DM 6588 F
Compliance
The equipment
is intended
professional audio applications.
Note: This device is not intended to be connected
directly to a public internet network.
EMC conformance to Environment E2: Commercial
and Light Industrial.
Testing is based on the use of supplied and
recommended cable types.
The use of other than shielded (screened) cable
types may degrade EMC performance.
Changes or modifications not expressly approved
by Shure Incorporated could void your authority
to operate this equipment.
This Class B digital apparatus complies with
Canadian ICES-003. Cet appareil numérique de la
classe B est conforme à la norme NMB-003 du
Canada.
Authorized under the verification provision of FCC
Part 15B.
Please follow your regional recycling scheme for
batteries, packaging, and electronic waste.
Information to the user
This equipment has been tested and found to
comply with the limits for a Class B digital device,
to be used
in
•
DM 6080 F
•
DM 6620 F
•
DM 6501 F
•
CM 6080 F
•
CM 6680 F
To avoid moisture condensations do not install the
units where the temperature may rise rapidly.
To avoid moisture condensations do not install the
unit where the temperature may rise rapidly.
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause
harmful
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase
the
equipment and the receiver.
•
Connect the equipment to an outlet on a
circuit different from that to which the
•
receiver is connected.
•
Consult the dealer or an experienced
radio/TV technician for help.
3
User Manual
interference
to
separation
between
radio
the
Advertisement
Table of Contents
