Table of Contents
Advertisement
Auto Mode and Auto Speed Settings:
Set single or Master/Slaved units to run in auto mode at user selectable speeds.
Auto Mode:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to navigate to AUTO, and press
the <ENTER> button.
2.) Now use the <UP/DOWN> buttons to highlight any program ranging from AT01-AT22,
and press <ENTER>.
3.) From here, you can now adjust the auto speed. Use the <UP/DOWN> buttons to select a
value ranging from 0-255 (fast <--> slow), and press <ENTER> to confirm.
4.) In this same menu level as AT01-AT22, you can also edit INTE (overall LED intensity
output level: 0-255), ACCT (color change after set number of loops: 1-255), and ATMD which
allows for 3 different auto mode selection types: STEP (individual steps, triggered by TAP SYC
on footswitch), 1SHT (run program once, triggered by TAP SYC on footswitch), and LOOP
(loops a running auto program).
Sound Active Mode:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to AUTO and press <ENTER>,
then with the <UP/DOWN> buttons navigate to SOU1 (color change), or SOU2 (white strobe
only), and press the <ENTER> button.
Fixture Reset Functions:
Allows users to reset the fixture to factory default settings with the exception ADDR or WADD.
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to LOAD and press <ENTER>,
then use the <UP/DOWN> buttons to highlight YES or NO, then press <ENTER>.
2.) The reset function will reset all default values with the exception of those in ADDR
(address), and WADD (wireless address).
Footswitch Setup:
Setting up the wireless footswitch pedal to control your fixture(s).
Set the Footswitch Wireless Address:
1.) Navigate the main menu of the fixture(s) to be controlled by the footswitch to reach SET and
then press <ENTER>.
2.) Use the <UP/DOWN> buttons to scroll to WADD, and press <ENTER>.
3.) Now use the <UP/DOWN> buttons to select any frequency from 0-F , and press <ENTER>.
4.) On the footswitch, use the channel selection button to choose the same frequency that is set
on the fixture(s) from 0-F. Note: When the channel selection button is not in use for 10s, the LED
display will show the remaining battery power level from 0-9.
Multiple Fixtures With Footswitch Control:
Multiple Wireless Fixtures
1.) Swivel the antennas on all fixtures and footswitch to their outward extended positions.
2.) Set all Starting DMX Addresses and DMX Channel Modes to match.
3.) Set the wireless frequency on all fixtures to match the set footswitch frequency (0-F).
Wireless Fixture to DMX Cable Wired Fixtures
1.) Swivel the antennas on 1st fixture and footswitch to their outward extended positions.
2.) Set all Starting DMX Addresses and DMX Channel Modes to match.
3.) Set the wireless frequency on the 1st fixture to match the set footswitch frequency (0-F).
4.) Starting with the 1st fixture that is wirelessly controlled by the footswitch, you can daisy
chain the Sync Dmx Out to the DMX In of the second fixture, then connect the DMX Out of
the 2nd fixture to the DMX In of the 3rd fixture, and so on to other fixtures.
Note: The first fixture in the DMX chain is the only fixture needing to use the Sync Dmx Out
port. Both of the Sync Dmx Out rear connections (male and female) are outputs.
Weather System EXA Manual Rev. A
Page 13
© 2016 Blizzard Lighting, LLC
Hide quick links:
Advertisement
Table of Contents
