Debug Probe Setting - Epson S1C31D01 Software Manual

2.4.4

Debug Probe Setting

Before debugging an active project using the target board connected to the debug probe, you need to select a
driver for the debug probe, if necessary.
To select the debug probe driver, follow the procedure below.
(1) Select the [Project] > [Options for {project} - Target '{build configuration}'] in the uVision menu.
(2) Switch the [Debug] tab in the [Options for Target '{build configuration}'] dialog (Figure 2.4.4.1).
(3) Select the "J-Link/J-TRACE Cortex" from the drop-down list at the right side of [Use:] checkbox
(Figure 2.4.4.1).
(4) Click the [Settings] button at the right side of the above drop-down list (Figure 2.4.4.1).
(5) Select the [SW] from the [Port:] drop-down list in the [Cortex JLink/JTrace Target Driver Setup] dialog
box.
(6) Click the all [OK] button to close all dialogs.
Notes:
•
This setting needs to be done with J-Link connected to the PC.
•
If "setup-debugger-jlink.bat" described in "2.4.1 Software Setup" has already been executed, the debug
probe (J - Link) setting is applied to all projects in the sample software. However, if the debug probe does
not recognize normally, follow the above procedure to check the settings.
S1C31D01 Peripheral Circuit
Sample Software Manual (Rev.3.00)
Figure 2.4.4.1 Debug Probe Selecting
Seiko Epson Corporation 17