Iar Ewarm Ide Sample Software Procedures; Software Setup - Epson S1C31D01 Software Manual

2.3 IAR EWARM IDE Sample Software Procedures

2.3.1

Software Setup

Before executing the sample software using the IAR EWARM, you need to set up the sample software. To set up
the sample software, follow the procedure below.
(1) Download the sample software
Download the S1C31D01 Peripheral Circuit Sample Software Package (.exe) from Seiko Epson
microcontroller web site.
(2) Install the Peripheral Circuit Sample Software Package
Close all other programs during this installation. Run downloaded Peripheral Circuit Sample Software
Package executable file as administrator. Review the license terms before proceeding with installation.
Select desired folder package to be installed into and select "Install". After the software has been installed
into the destination, a setup utility called "ToolchainSetup.exe" will automatically launch. Press "Next" on
setup utility, and select your preferred versions of IAR EWARM identified by the checkboxes. [Note: The
setup utility will copy some flashing binaries and device description files into your IAR folders]. Press
"Next" to begin the setup, and when the "Done" message appears select "Finish" to complete.
(3) Launch the IAR EWARM
Once the software setup has completed successfully, launch the IAR EWARM.
For the version of IAR EWARM used to evaluate this sample software and more information on the setup utility,
refer to the "README_IAR.txt" found in this sample software package.
6 Seiko Epson Corporation
S1C31D01 Peripheral Circuit Sample
Software Manual (Rev.3.00)