Table of Contents
Advertisement
Q40 Tape Library
6.19.2.5
Network Status
To see the configuration and status of the library's network settings navigate to the Status > Network
Status page.
On the network status page you can see:
•
Host Name – Library hostname
•
Domain Name
•
Protocol – IPV4 or IPv6
•
MAC Address – A unique identifier for the library controller network interface
•
Link Status – Enabled or disabled
•
Link Speed – Speed of the Ethernet connection to the library
•
Duplex – Enabled or disabled
IPv4 settings
•
DHCP – When Enabled, the library requests an IP address from a DHCP server each time
the library is powered on.
•
Address – IP address in use by the library. If DHCP is enabled, this address was obtained
from the DHCP server. When DHCP is not enabled, the address was configured.
•
Netmask – The network mask of the library controller used when DHCP is not enabled.
•
Gateway – The gateway used when DHCP is not enabled.
•
DNS 1
•
DNS 2
IPv6 settings
•
Stateless Addressing – When Enabled, the device will generate an address for itself based
on the routing information obtained from a router advertisement and the MAC address. The
device can manage up to five global addresses at the same time, which can be assigned
from different routers.
•
Static Addressing – When Enabled, the library will use a statically-configured address.
•
Static Assigned Address – The IPv6 address when Static Addressing Enabled is On.
511026 Rev. 07-01-19
Installation and Operations Manual
118
Advertisement
Table of Contents
